Configuring the target NetPilot for NAT-T operation
You must be running version 3.0.5 or later software on the target NetPilot. You need to set up the Road Warrior VPN profile in the standard manner - there is nothing extra to configure for NAT-T operation, but there are differences to the client configuration as described below.

Configuring the local firewall for NAT-T operation
The local NAT firewall must have UDP ports 500 and 4500 outbound to the Internet open.

If the local firewall is a NetPilot - they why are you not configuring the local NetPilot and the remote target NetPilot to operate in site to site mode ? (i.e. this is the most efficient Config) If you are doing this for demonstration purposes then you must change the NetPilot firewall to allow all outgoing connections.

Obtaining the spd policy file for your VPN client for NAT-T operation

If you wish to use DemoPilot-NAT-T.spd security policy with your Safenet VPN client on a PC siting behind a firewall using NAT :

To download the SPD file : Click and Save on your PC !

Screen shots of how DemoPilot-NAT-T.spd appears in Policy Editor

To review the Policy Editor screens for this SPD file, with hints on modification for your own use : Click Here !

Product Information :

For Client : Click Here !

For General VPN : Click Here !

Safenet Support Site : Click Here !